Operation Manual

BX25, RCK54(P)-23BX. RCK60B-23BX, LA240, BT601, WSM
FRONT AXLE
Front Wheel Steering Angle
1. Inflate the tires to the specified pressure.
2. Loosen the lock nut and shorten the length of stopper bolt LH (1).
3. Steer the wheels to the extreme left.
4. Lengthen the length of stopper bolt (1) until the stopper bolt
contacts with the bevel gear case (3).
5. Return the steering wheel to straight ahead and lengthen the
stopper bolt four turn from above position further.
6. Lock the stopper bolt by lock nut (2).
7. For adjusting the right steering angle. perform the same
procedure as mentioned
in left steering angle.
(Reference)
Steering angle
Right side
0.84 to 0.87 rad
48 to
50 °
Left side
0.92 to 0.96 rad
53t055°
Length
of adjusting bolt
Right side
26mm
1.02 in.
(L)
Left side
21 mm
0.83 in.
(1) Stopper Bolt LH
(3) Bevel Gear Case
(2) Lock Nut
W1011846
[2] PREPARATION
• Before proceeding this section, disassembling the loader assembling and backhoe. (Refer to section 8
and 9.)
(1) Separating Front Axle Assembly
Draining Front Axle Case Oil
1. Place the oil pans underneath the front axle case.
2. Remove both right and left hand side drain plugs (3) and filling
plug (2) to drain the oil.
3. After draining, reinstall the drain plugs (3).
(When reassembling)
• When re-filling, remove the right and left breather plugs (1) .
• IMPORTANT
• After ten minutes, check the oil level again, add oil to
prescribed level.
• Use KUBOTA SUPER UDT fluid or SAE80, 90 gear oil.
Refer to "LUBRICANTS, FUEL AND COOLANT". (See page
G-7.)
147l
~.O U.S.qts
4.1Imp.qts
(1) Breather Plug
(A) Oil level is acceptable within this
(2) Filling Plug with Dipstick
range.
(3) Drain Plug
W1012192
3-S5