Operation Manual
BX25, RCK54(P)-23BX, RCK60B-23BX,
lA240,
BT601,
WSM
STEERING
[3]
DISASSEMBLING AND ASSEMBLING
(1) Power Steering
Cylinder
(3)
(2)
3TAAAAB7P013A
(4) (5) (6) A
3TAAAAB7P014A
A (2)
e'l
B •
i;-.:AIiI"l1):::II:::'I'III-----=-7/--
\
=ut..a..~d=-!Jl.l.l--I
--
(4)
\ I
t
3TAAAAB7P015A 3
(7) (8)
(5) (6)
(4)
~J
3TAAAAB7P016A
Adaptor
and Tie-rod
1.
Remove the cylinder hose adaptors (4), (6).
2.
Remove the tie-rods (2), (8) from piston rod (7).
3.
Remove the cylinder holder (1) and internal snap ring (3).
(When reassembling)
a Be sure to install the hose adaptors (4), (6) as shown figure left.
a After reassembling the tie-rod, be sure to adjust the toe-in.
(Refer to 3-S4.)
74
to
84
N'm
TIghtening torque
Tie-rod screw
7.5
to
8.6
kgf·m
54.6
to
61.9 ft-Ibs
(1) Cylinder Holder
(7) Piston Rod
(2) Tie-rod RH (8) TIe-rod LH
(3) Internal Snap Ring
(4)
Hose
Adaptor RH
A:
0.26
rad
(15°)
(5) Cylinder
B:
Front
(6)
Hose
Adaptor
LH
W1012941
Steering
Cylinder
1.
Carefully clamp the cylinder
in
a vise.
2. Push one of the guide assembly (3) to inside
of
cylinder tube (2).
3.
Drill a hole (2.5 mm dia.,
0.1
in. dia.)
on
the cylinder tube (2)
just
over the snap ring (4) as shown figure left.
4. Take a little screwdriver and lift
off
the snap ring (4) from its
groove. Simultaneousness support this action by pushing from
the outside
of
the cylinder tube with another little screwdriver or
another tool.
5.
Push out the piston rod assembly (9) and take off the guide
assembly (3).
(When reassembling)
• NOTE
• Seals
must
be exchanged
after
disassembling.
•
Apply
transmission
fluid
to
the exchanged seals.
•
Enter
the
piston
rod
and
block
the
guide
assemblies
with
the
snap
rings.
(1) Piston Rod
(8) O-ring
(2) Cylinder Tube
(9) Piston Rod
Assembly
(3) Guide Assembly
(10) Center Piston
(4) Snap Ring
(5) Guide
A:
Drill a Hole
(6)
Seal Ring
B : 5.25
mm
(0.267 In.)
(7) Wiper Ring
W1013441
4-S8