Operation Manual
BX25,
RCK54(P)-23BX,
RCK60B-23BX,
LA240,
BT601,
WSM
G GENERAL
[2] CHECK POINTS OF INITIAL
50
HOURS
Changing Engine Oil
A CAUTION
• Be sure
to
stop
the engine before changing engine oil.
1.
Start and warm up the engine for approx. 5 minutes.
2.
Place an oil pan underneath the engine.
3.
To drain the used oil, remove the drain plug (1) at the bottom
of
the engine and drain the oil completely.
4.
Screw
in
the drain plug (1).
5.
Fill new oil up to upper line on the dipstick (3) .
• IMPORTANT
• When using an
oil
of
different manufacture
or
viscosity
from
the previous one, remove all
of
the old oil.
• Never
mix
two
different types
of
oil.
• Use the proper SAE Engine Oil according
to
ambient
temperatures.
• Refer
to
"LUBRICANTS, FUEL AND COOLANT". (See page
G-7.)
Engine oil capacity
3.n
3.3 U.S.qts
2.7Imp.qts
(1) Drain
Plug
IA)
Oil level
is
acceptable
within
this
(2)
Oil
Inlet
range.
(3)
Dipstick
W1014065
Replacing Engine Oil Filter
A CAUTION
• Be sure
to
stop
the engine before changing oil
filter
cartridge.
1.
Remove the oil filter.
2.
Put a film
of
clean engine oil on the rubber seal
of
the new filter.
3.
Tighten the filter quickly until it contacts the mounting surface.
Tighten filter by hand
an
additional
1/2
turn only.
4. After the new filter has been replaced, the engine oil normally
decrease a little. Make sure that the engine oil does not leak
through the seal and be sure to check the
oil level
on
the dipstick.
Then, replenish the engine oil up to the specified level.
5.
Properly dispose
of
used oil.
• IMPORTANT
• To prevent serious damage
to
the engine, replacement
element
must
be
highly
efficient. Use
only
a KUBOTA
genuine
filter
or
its
equivalent.
(1) Engine
Oil
Filter Cartridge
W1014316
G-12