Operation Manual

BX25, RCK54(P)-23BX, RCK60B-23BX, LA240, BT601, WSM
HYDRAULIC SYSTEM
[2] PREPARATION
• Before proceeding this section, disassembling the loader assembling and backhoe. (Refer to section 8
and
9.)
(1) Separating Hydraulic Cylinder
Battery
A CAUTION
• When disconnecting the battery cables, disconnect the
negative cable from
the battery first. When connecting,
connect the positive cable
to the battery first.
1. Remove the under panel (1).
2. Disconnect the negative cable (2) from the battery.
(1) Under Panel
(3) Negative Cable
(2) Battery
W1026961
Roll-Over Protective Structures (RaPS) and Seat
1. Disconnect the lead wires from the hazard lights (2), (4) and turn
signal lights (3), (5).
2. Remove the ROPS mounting nuts, and remove the ROPS (1).
3. Disconnect the seat switch connectors.
4. Remove the snap pin (7) and remove the seat (6).
(When reassembling)
124 to 147 N'm
nghtening torque ROPS mounting nut 12.6 to 15.0 kgf-m
91.2
to 108 ft-Ibs
(1) ROPS
(5) Turn Signal Light RH
(2) Hazard Light
LH
(6) Seat
(3) Turn Signal Light LH
(7) Snap Pin
(4) Hazard Light RH
W1027220
Speed Control Pedal and Step
1. Remove the valve covers (3).
2. Remove the speed control pedals (1) and step (2).
(1) Speed Control Pedal
(3) Valve Cover
(2) Step
W1014726
5-S7