Operation Manual

BX25, RCK54(P}-23BX, RCK60B-23BX, lA240, BT601, WSM
HYDRAULIC SYSTEM
Roll-Over Protective Structures (ROPS) and Seat
1. Disconnect the lead wires from the hazard lights (2), (4) and turn
signal lights (3), (5).
2. Remove the ROPS mounting nuts, and remove the ROPS (1).
3. Disconnect the seat switch connectors.
4. Remove the snap pin (7) and remove the seat (6).
(When reassembling)
124 to 147
N'm
nghtening torque ROPS mounting nut 12.6 to 15.0 kgf·m
91.2 to 108 ft-Ibs
(1) ROPS (5) Tum Signal Light
RH
(2) Hazard Light LH (6) Seat
(3) Turn Signal Light
LH
(7) Snap
Pin
(4) Hazard Light RH
W1019672
Speed Control Pedal and Step
1. Remove the valve covers (3).
2. Remove the speed control pedals (1) and step (2).
(1) Speed Control Pedal (3) Valve Cover
(2) Step
W12345678
Lever Grips and Fender
1. Disconnect the electric outlet connector (6).
2. Remove the lowering speed adjusting knob (5) and cutting height
adjusting dial knob
(4).
3. Remove the lever grips (2).
4. Remove the fender (1) with lever guide (3).
(1) Fender
(4) Cutting Height Adjusting Dial Knob
(2) Lever Grip
(5) Lowering Speed Adjusting Knob
(3) Lever Guide
(6)
Electric Outlet
W85236974
Fuel Tank
1. Drain the fuel.
2. Disconnect the lead wire from fuel level sensor and fuel hoses
from the fuel tank (1).
3. Remove the fuel tank stays (2), (3) and cushions, then remove
the fuel tank (1).
4. Remove the PTO cover (4).
(When reassembling)
Tightening torque
Fuel tank stay mounting
bolt and nut
48.1 to 55.9 N'm
4.9 to 5.7 kgf·m
35.4 to 41.2 ft-Ibs
(1) Fuel Tank
(3) Fuel Tank Stay RH
(2) Fuel
Tank Stay LH
(4)
PTO Cover
W1020301
5-S10