Operation Manual
BX25,
RCK54(P)-23BX,
RCK60B-23BX,
LA240,
BT601,
WSM
G GENERAL
Replacing Transmission Oil Filter
A CAUTION
•
Allow
engine
to
cool down sufficiently,
oil
can be
hot
and
can burn.
1.
Remove the oil filter.
2.
Put a film
of
clean transmission oil
on
the rubber seal
of
the new
filter.
3.
Tighten the filter quickly until it contacts the mounting surface.
Tighten filter by hand
an
additional
1/2
turn only.
4. After the new filter has been replaced, the transmission fluid level
will decrease a little. Make sure that the transmission fluid does
not leak through the seal, and check the fluid level. Top off
if
necessary.
5.
Properly dispose
of
used oil .
• IMPORTANT
• To prevent serious damage
to
the hydraulic system, use
only
a KUBOTA genuine filter.
(1) Transmission
Oil
Filter
W1014458
Cleaning Transmission Oil Strainer
1.
When changing the transmission fluid, disassemble and rinse the
strainer with nonflammable solvent to completely clean off
fillings.
2.
When reassembling, be careful not to damage the parts .
• NOTE
• Since
the
fine
fillings
in the iI can damage the precision
component parts
of
the
hydraulic
system, the end
of
the
suction line
is
provided
with
an
oil
strainer.
(1) Stainer (2) Filter Plate
W1014665
G-13