Operation Manual

I
BX25, RCK54(P)-23BX, RCK60B-23BX, LA240, BT601, WSM
ELECTRICAL SYSTEM
3TAAAAB9P046A
I
I
(1)~
AC 2!....A
3
)
~I
~I
I
~J
3TAAAAB9P047 A
Flasher Unit
1. Remove the under panel.
2. Disconnect the coupler (2) from flasher unit.
3. Measure the voltage with a voltmeter across the terminal hand
terminal c or chassis.
4. If the voltage differs from the battery voltage, the wiring hamess
is faulty.
Terminal h
Voltage
Approx. battery voltage
Terminal c
or Chassis
(1) Flasher Unit (2) Coupler
W1055033
Flasher Unit Actuation Test
1. Set the hazard switch to the ON position, and make sure the
hazard light gives 60 to
85 flashes for a minute.
2. With the main switch and the hazard switch at the ACC and ON
positions, respectively, move the turn signal light switch to the
left. Make sure that the right-hand light stays
on and the left-hand
light gives flashes earlier (by about
20 flashes) than when the
hazard lamp
is activated. Then move the turn signal light switch
to the right and make sure the corresponding actions take place.
3. Now set the main switch to the ACC position and move the
blinker switch alone. Make sure the same actions as above
result.
4. If both the hazard switch and the turn signal light switch function
but the above actions do not take place, replace the flasher unit
with new one.
(1) Hazard Light Switch
(3) Flasher Unit
(2) Turn Signal Light Switch
W10456987
6-S22