Operation Manual
BX25,
RCK54(P)-23BX,
RCK60B-23BX,
LA240,
BT601,
WSM
ROTARY
MOWER
(3)
3TAAAAFMP033B
Adjusting
Front
and Rear
Cutting
Height
1.
Tire pressure must be correct.
2.
Make sure the level
of
the mower blades
is
adjusted as shown
below. Then tighten the lock nuts securely.
3.
Turn the cutting height control dial to "2.0" and the anti-scalp
roller's height to keep clearance between rollers and ground from
6 to 13 mm (0.25 to 0.5 in.).
4. Turn right blade by hand parallel to direction of travel.
5.
Adjust (L) of front links with lock nuts so that A
is
0 to 5 mm
(0
to
0.2 in.) A
= (R)-(F).
6.
If the difference between front tip and rear tip of blade
is
not
within the factory speCification, adjust the length L
of
front link
with lock nut (3). The height of rear blade tip R should be bigger
than the front.
Difference (R-F)
(R
<:
F)
0.0105.0 mm
between front tip and Factory spec.
0.0 to 0.20
in.
rear tip
of
blade
(1) Cutting Height Control Dial
L:
Length
of
Front
Link
(2) Hydraulic Control Lever
F:
Height
of
Blade Tip (Front)
(3) Lock Nut
R : Height
of
Blade Tip (Rear)
W1018083
F
R
3TAAAAFMP037A
7-512