Operation Manual

BX25, RCK54(P)-23BX, RCK60B-23BX, LA240, BT601! WSM
ROTARY MOWER
Adjusting Left and Right Cutting Height
1. Tire pressure must be correct.
2. Operate the hydraulic control lever (2) rearward to raise the
mower deck to the highest position.
3. Stop the engine and remove the key.
4. Turn the cutting height control dial to the desired height.
5. Set the anti-scalp roller's height to keep clearance between
rollers and ground from 6 to 13 mm (0.2 to 0.5 in.).
6. Lower the mower deck by moving the hydraulic control lever
forward.
7. Turn left blade by hand parallel to tractor axle and turn right blade
parallel to axle to measure from the outside blade tip at
Land R
to the level surface.
8. The difference between measurement should be less than 3 mm
(0.12in.).
9. If the difference between measurement is more than 3 mm (0.12
in.), loosen the lock nut
of the left side.
10.Adjust the cutting height fine turning bolts so that the difference
between measurement
Land R is less than 3 mm (0.12 in.).
Then lock the nut.
Difference (L-R)
3GMAAACMP026A
Less than 3
mm
between left tip and right
Factory spec.
0.12 in.
tip of blade
(1) Cutting Height Control Dial
L: Left Blade Measurement Position
(2) Hydraulic Control Lever R: Right Blade Measurement
(3) Cutting Height Fine Tuming Bolt
Position
(4) Lock Nut
A : Blade Height
W1018567
3TAAAAFMP013A
(3)--grr
(4)r-w-l
H
7-S13