Operation Manual

BX25, RCK54(P)-23BX, RCK60B-23BX, LA240, BT601, WSM
G GENERAL
IF
3TAAAAGOP010A
Adjusting Brake Pedal Free Travel
A CAUTION
•
Stop the engine, remove the key, lower the implement to the
ground, and chock the wheels before checking brake pedal.
• Even
if the brake pedal free travel is within the limitation,
adjust the brake pedal following the procedure below.
1. Release the parking brake.
2. Loosen the lock nut and turn the turnbuckle to adjust the rod
length so that the brake pedal free travel is 10 mm (0.4 in.).
3. Extend the turnbuckle one additional turn.
4. Retighten the lock nut.
5. Depress the brake pedal several times and make sure the brake
pedal free travel is from 25 to
35 mm (1.0 to 1.4 in.).
25 to
35mm
Brake pedal free travel
Factory spec.
1.0 to 1.4 in.
(1) Tumbuckle A: Free Travel
(2) Lock Nut
W1018144
[5] CHECK POINTS OF EVERY 200 HOURS
Changing Engine Oil
1. See page G-12.
W1043804
Replacing Engine Oil Filter
1. See page G-12.
W1018516
Replacing Transmission Oil Filter
1. See page G-13.
W1043871
Checking Radiator Hoses and Hose Clamps
Check to see
if radiator hoses are properly fixed every 200 hours
of operation or six months, whichever comes first.
1. If hose damps are loose or water leaks, tighten clamps securely.
2. Replace hoses and tighten hose clamps securely, if radiator
hoses are swollen, hardened or cracked.
3. Properly dispose of used coolant.
Replace hoses and hose clamps every 2 years or earlier if
checked and found that hoses are swollen, hardened or cracked.
• Precaution
at Overheating
Take the following actions
in the event the coolant temperature
be nearly or more than the boiling point, what
is called
"Overheating" .
1. Stop the machine operation in a safe place and keep the engine
idling unloaded.
2. Don't stop the engine suddenly, but stop it after about 5 minutes
of unloaded idling.
3. Keep yourself well away from the machine for an additional 10
minutes or until the steam has blown out.
4. Checking that there is no danger such as burn. get rid of the
cause of overheating according to the manual. see "ENGINE"
section. and then, start the engine again.
(1) Radiator Hose
(2) Hose Clamp
W1018562
G-22