Operation Manual

BX25, RCK54(P)-23BX, RCK60B-23BX, LA240, BT601, WSM
G GENERAL
Checking Power Steering Line
A CAUTION
• Be sure
to stop the engine and remove the key before
checking power steering line.
1. Check to see that all lines are tight and not damaged.
2. If hoses are found to be worn or damaged, replace or repair them
at once.
(1) Power Steering Hose
W1018751
Checking Intake Air Line
1. Check to see that hose and hose clamps are tight and not
damaged.
2. If hose and clamps are found to be worn or damaged, replace or
repair them at once.
(1) Hose (2) Clamp
W1018915
Adjusting Toe-in
1. Park tractor on a firm, flat and level place.
1 ~
2. Turn steering wheel so front wheels are in the straight ahead
t
position.
"I
3. Lower the implement to the ground, lock the parking brake, stop
(C)
the engine and remove the key.
4. Measure distance between tire beads at front of tire at hub
height.
5. Measure distance between tire beads at rear of tire at hub height.
(8)
6. Front distance should be 0 to 5 mm (0 to 0.19 in.) less that rear
3TMABABOP042A
distance.
If not, adjust tie rod length.
(A)
010 5 mm
Toe-in «(8) - (Al)
Factory spec.
OtoO.19
in .
• Adjusting
1. Loosen the lock nuts and turn the steering tie-rod to adjust the
rod length until the proper toe-in measurement is obtained.
2. Retighten the lock nuts.
(1) Lock Nul
(A) Wheel to Wheel Distance at Front
(2) Tie-rod
(8) Wheel to Wheel Distance at Rear
(e) Front
W1019009
G-23