Operation Manual

BX25, RCK54(P)-23BX. RCK60B-23BX. LA240. BT601. WSM
G GENERAL
[6] CHECK POINTS OF EVERY 400 HOURS
(1 )
(3)
(2)
e
~: (A)
\\~
. (1)
w,IF
~~;~
(3) ~
Changing Transmission Fluid
1. See page G-13.
W1019295
Cleaning Transmission Oil Strainer
1. When changing the transmission fluid, disassemble and rinse the
strainer with nonflammable solvent to completely clean
off
fillings.
2. When reassembling, be careful not to damage the parts .
• NOTE
• Since the fine
fillings in the oil can damage the precision
component parts
of the hydraulic system, the end of the
suction line is provided
with an oil strainer.
(1) Strainer
(2) Filter Plate
W1019390
Changing Front Axle Case Oil
1. Park the machine on a firm, flat and level surface.
2. To drain the used oil, remove the right and left drain plugs and oil
gauge
at the front axle case and drain the oil completely into the
oil pan.
3. After draining, reinstall the drain plugs.
4. Remove the right and left breather plugs.
5. Fill with new oil up to the upper notch on the dipstick.
• IMPORTANT
•
After ten minutes, check the oil level again; add oil to
prescribed level.
6. After filling, reinstall the oil gauge and breather plugs.
Front axle case oil capacity
4.7l
5.0 U.S.qts
4.1Imp.qts
(1) Breather Plug
(A)
011 level is acceptable within this
(2) Oil Gauge with Dipstick
range.
(3) Drain Plug
W1019508
G-24