Operation Manual

BX25. RCK54(P)-23BX. RCK60B-23BX. LA240. BT601. WSM
FRONT LOADER
[3] LUBRICANTS
To prevent serious damage to hydraulic system. use only specified fluid or its equivalent.
Place Capacities
Lubricants
Transmission Case
11.6 L
3.1 U.S.gals
2.6 Imp.gals
KUBOTA SUPER UDT
Fluid"
Grease fitting
Until grease overflows
Moly
Ep Type grease
• NOTE
• * KUBOTA SUPER UOT Fluid .................. KUBOTA original transmission hydraulic fluid
W1010650
[4] MAINTENANCE CHECK LIST
To keep the machine working in good condition as well as to avoid any accident and trouble, carry out periodic
inspection and maintenance. Check the following points before use.
Service Internal Check
Points
Reference
Page
Daily (Each use) Check the transmission fluid level
8-S2
Check the hydraulic hoses
8-S2
Every 10 hours
Grease all grease fitting 8-S3
Lubricate joints of control lever linkage 8-S3
3TVAAACLP003A (1)
W1010764
[5] CHECK AND MAINTENANCE
A CAUTION
• When
checking and repairing, park the tractor on flat ground and apply the parking brake.
• When
checking and repairing, lower the bucket and stop the engine.
(1) Check Points of Each Use or Daily
Checking Transmission Fluid Level
1. Check the oil level at the dipstick (1).
2. If the level is too low, add new oil to the prescribed level at the oil
inlet.
• IMPORTANT
•
If oil level is low, do not run engine.
(1) Dipstick
A: Oil level is acceptable within this
range.
W1010960
Checking Hydraulic Hoses
1. Checking all hydraulic hoses for cuts or wear.
2. If defects are found, replace them.
(1) Hydraulic Hose
(3) Magnifying Glass
(2) Cardboard
W1011064
8-S2