Operation Manual
BX25, RCK54(P)-23BX, RCK60B·23BX, LA240, BT601, WSM
FRONT LOADER
(3)
5.
DISMOUNTING AND MOUNTING FRONT LOADER
FROM TRACTOR
• IMPORTANT
• When
dismounting
the
front
loader, park the
tractor
on flat and hard ground,
apply
the parking brake.
• When starting the engine
or
using the hydraulic control valve, always
sit
on the operator's seat.
[1]
DISMOUNTING FRONT LOADER FROM TRACTOR
Side Frame
1.
Raise the boom until the stands (1) can be rotated.
2.
Stop the engine.
3.
Remove the spring pin (2) holding the stand (1) to the boom.
4.
Slide the stands (1) leftward and rotate it until the hole
in
the
stand and pin on the boom are aligned. Then slide the stand (1)
rightward and insert the spring pin (2) as shown.
5.
Start the engine
and
run at idle.
6.
Dump the bucket approximately 20 degrees.
7.
Lower the boom and raise the front wheels slightly .
• IMPORTANT
•
Lift
the
front
wheels
with
the bucket. Do
not
attempt
to
lift
the with the stand.
8.
Stop the engine.
9.
Remove the mounting pins from the loader side frames and hold
them
in
the plate of side frame.
10.Start the engine and
run
at idle. Slowly move the hydraulic
control lever (3) to rollback position to raise the loader side
frames up and out
of
the receives of the main frames as shown.
11.Stop the engine.
12.Slowly release all hydraulic pressure by moving the hydraulic
control lever (3)
in
all directions.
13.Disconnect the four hoses with quick couplers at the control valve
and place them on the right side
of
the boom.
14.Place the protective caps and plugs (4) on the quick coupler
ends.
15.
Start the engine and slowly back the tractor away from the loader.
(1) Stand
(3) Hydraulic Control Lever
(2) Spring Pin
(4) Protective Plug
W1012789
8-S9