Operation Manual
BX25,
RCK54(P)-23BX,
RCK60B-23BX,
LA240,
BT601,
WSM
ENGINE
Oil Pan and Oil Strainer
1.
Remove the oil pan mounting screws (1).
2. Remove the oil pan (2)
by
lightly tapping the rim
of
the pan with
a wooden hammer.
3.
Remove the oil strainer (3).
(When reassembling)
• After cleaning the oil strainer, check to see that the filter mesh
in
clean, and install it.
• Visually check the O-ring (4), apply engine oil, and install
it.
• Securely fit the O-ring to the oil strainer.
• To avoid uneven tightening. tighten oil pan mounting screws
in
diagonal order form the center.
• Using the hole (6) numbered "3", install the oil strainer
by
mounting screw
• IMPORTANT
• Scrape
off
the old adhesive completely. Wipe the sealing
surface clean using waste
cloth
soaked
with
gasoline. Now
apply new adhesive 3
to
5 mm (0.12
to
0.20 in.)
thick
all over
the contact surface. Apply the adhesive
also
on
the
center
of
the flange as well as on the
inner
wall
of
each
bolt
hole.
• Cut the nozzle
of
the
"liquid
gasket" (Three Bond 12070
or
equivalent) container
at
its second notch.
Apply
"liquid
gasket" about 3
to
5 mm (0.12
to
0.20 in.) thick.
Within
20
minutes after the application
of
fluid
sealant.
reassemble the components. Wait then
for
about
30
minutes, and
pour
oil in the crankcase.
(1)
on
Pan
Mounting Screw (4) O-ring
(2) Oil Pan (5) Hole Numbered
"2"
(3) Oil Strainer (6) Hole Numbered "3"
W10236610
(4)
~151
3TAAAAB1P056C
3TAAAAB1P057A
1-S29