OPERATOR'S MANUAL
Table Of Contents
- OPS - Excavator K008-3 (RA028-8222-2)
- List of Abbreviations
- General Symbols
- Foreword
- Safety First
- Contents Page
- Safe Operation
- Dealer Service
- Technical Data
- Description of Machine Parts
- Instrument Panel and Control Elements
- Before Start
- Operation of the Engine
- Excavator Operation
- Control Observations During Operation
- Running In of the New Excavator
- Starting
- Controls for Attachments
- Operation of the Boom
- Operation of the Arm
- Operation of Bucket
- Swivel (Unit Swing) Operation
- Boom Swing Operation
- Boom Swing Pedal
- Operation of Track Width Change and Dozer
- Driving
- Turns
- Up and Downhill Travelling
- Parking on a Slope
- Drive Speed Pedal
- Service Port Operation
- Important Information on Excavator Operation
- Operating Foldable ROPS
- Transporting the Excavator on a Truck
- Lifting of the Excavator
- Maintenance
- Regular Checks and Maintenance Work
- Other Adjustments and Replacements
- Troubleshooting
- Operation in Cold Weather Conditions
- Long Storage
- Recommended Oils
- Main Dimensions
- Lifting Capacity
-1SAFE OPERATION
SAFE OPERATION
The best insurance against accidents is to abide
by the safety regulations.
Read and understand this section carefully,
before operating the excavator.
Every user, however experienced, should
carefully read and understand this section and
those of the attachments and accessories
before taking the excavator into operation. The
owner is obliged to inform the operators of these
instructions in detail.
Keep this manual in the toolbox.
1. BEFORE OPERATION
1. Make yourself acquainted with the excavator
and be aware of its limits. Read this
operator's manual carefully before starting
the excavator.
2. Obey the danger, warning and caution
labels on the machine.
3. For your safety, ROPS (Roll-Over Protective
Structure) with a seat belt is installed.
Always use seat belt when the machine is
equipped with a ROPS.
Do not modify structual members of ROPS
by welding, drilling, bending, grinding or
cutting, as this may weaken the structure. If
any component is damaged, replace it. Do
not attempt repairs. If ROPS is loosened or
removed for any reason, make certain all
parts are reinstalled correctly. Tighten
mounting bolts to proper torque.
4. The seat belt must be inspected regularly
and replaced if damaged.
5. Track can be set at the narrow width 700mm
and the standard width 860mm.
(for details see "OPERATION OF TRACK
WIDTH CHANGE AND DOZER")
Do not operate in narrow track width
700mm, there is a risk of the excavator
tipping over, always operate in standard
track width 860mm, except to pass through
a narrow space on even ground.
6. Do not use the excavator under the
influence of alcohol, medication or other
substances. Fatigue is also dangerous.
7. Check the surroundings carefully before
using the excavator or when attachments
are being attached.
A Pay attention to the overhead clearance with
electric wires.
A Check for pipes and buried cables.
A Check for hidden holes, hindrances, soft
ground and overhangs.
(1) Seat belt