OPERATOR'S MANUAL
Table Of Contents
- OPS - Excavator K008-3 (RA028-8222-2)
- List of Abbreviations
- General Symbols
- Foreword
- Safety First
- Contents Page
- Safe Operation
- Dealer Service
- Technical Data
- Description of Machine Parts
- Instrument Panel and Control Elements
- Before Start
- Operation of the Engine
- Excavator Operation
- Control Observations During Operation
- Running In of the New Excavator
- Starting
- Controls for Attachments
- Operation of the Boom
- Operation of the Arm
- Operation of Bucket
- Swivel (Unit Swing) Operation
- Boom Swing Operation
- Boom Swing Pedal
- Operation of Track Width Change and Dozer
- Driving
- Turns
- Up and Downhill Travelling
- Parking on a Slope
- Drive Speed Pedal
- Service Port Operation
- Important Information on Excavator Operation
- Operating Foldable ROPS
- Transporting the Excavator on a Truck
- Lifting of the Excavator
- Maintenance
- Regular Checks and Maintenance Work
- Other Adjustments and Replacements
- Troubleshooting
- Operation in Cold Weather Conditions
- Long Storage
- Recommended Oils
- Main Dimensions
- Lifting Capacity
15EXCAVATOR OPERATION
C Pattern Change
Switching from [Pattern A] to [Pattern B]
1. Stop the engine and place the front
attachment on the ground. Release
pressure out of the cylinders.
2. Turn the knob on the control box to open the
cover.
3. Remove the bolts (1) and (2).
4. Shift the joints (C) and (D) to the right, and
apply and tighten up the bolts (1) and (2).
To avoid personal injury:
A The bolts (1) and (2) are of special
type. Do not use general bolts,
because otherwise the machine may
malfunction and get damaged.
(1) Knob
(1) Bolt1
(2) Bolt2
(3) Joint (C)
(4) Joint (D)
(1) Bolt1
(2) Bolt2
(3) Joint (C)
(4) Joint (D)