OPERATOR'S MANUAL

Table Of Contents
16 EXCAVATOR OPERATION
C Switching from [Pattern B] to [Pattern A]
1. Stop the engine and place the front
attachment on the ground. Release
pressure out of the cylinders.
2. Turn the knob on the control box to open the
cover.
3. Remove the bolts (1) and (2).
4. Shift the joints (C) and (D) to the left, and
apply and tighten up the bolts (1) and (2).
To avoid personal injury:
A The bolts (1) and (2) are of special
type. Do not use general bolts,
because otherwise the machine may
malfunction and get damaged.
(1) Knob
(1) Bolt1
(2) Bolt2
(3) Joint (C)
(4) Joint (D)
(1) Bolt1
(2) Bolt2
(3) Joint (C)
(4) Joint (D)