OPERATOR'S MANUAL
Table Of Contents
- OPS - Excavator K008-3 (RA028-8222-2)
- List of Abbreviations
- General Symbols
- Foreword
- Safety First
- Contents Page
- Safe Operation
- Dealer Service
- Technical Data
- Description of Machine Parts
- Instrument Panel and Control Elements
- Before Start
- Operation of the Engine
- Excavator Operation
- Control Observations During Operation
- Running In of the New Excavator
- Starting
- Controls for Attachments
- Operation of the Boom
- Operation of the Arm
- Operation of Bucket
- Swivel (Unit Swing) Operation
- Boom Swing Operation
- Boom Swing Pedal
- Operation of Track Width Change and Dozer
- Driving
- Turns
- Up and Downhill Travelling
- Parking on a Slope
- Drive Speed Pedal
- Service Port Operation
- Important Information on Excavator Operation
- Operating Foldable ROPS
- Transporting the Excavator on a Truck
- Lifting of the Excavator
- Maintenance
- Regular Checks and Maintenance Work
- Other Adjustments and Replacements
- Troubleshooting
- Operation in Cold Weather Conditions
- Long Storage
- Recommended Oils
- Main Dimensions
- Lifting Capacity
60 LIFTING CAPACITY
LIFTING CAPACITY
1. The lifting capacities are based on ISO 10567 and do not exceed 75% of the static tilt load of the
machine or 87% of the hydraulic lifting capacity of the machine.
2. The strokes are as follows.
(1) The load point corresponds to the front bolt part of the arm.
(2) The machine positions are (i) over-front (Blade up), (ii) over-front (Blade down), and (iii) over-
side.
(3) The operating cylinder is the boom cylinder.
3. The bucket of the excavator, the hook, the sling and other lifting accessories are taken into
consideration for the loads.
Machine conditions:
No bucket, all others according to standard regulations.
To avoid personal injury or death:
A It is forbidden to lift loads greater than those values mentioned in the lifting capacity
tables.
A The values mentioned in the table are valid only on even, hard ground. When lifting on
soft ground, the machine 'can tilt over due to the fact that the load is concentrated only
on one side of the machine.
The table values are calculated at the end of the arm without the bucket. In order to find
the allowable loads for machines with bucket, the bucket weight must be subtracted from
the values in the table.