OPERATOR'S MANUAL
Table Of Contents
- OPS - Excavator KX057-4, U55-4 (RD358-8131-6)
- ABBREVIATION LIST
- GENERAL SYMBOLS
- FOREWORD
- SAFETY FIRST
- CONTENTS PAGE
- SAFE OPERATION
- DEALER SERVICE
- TECHNICAL DATA
- DESCRIPTION OF MACHINE PARTS
- INSTRUMENT PANEL AND CONTROL ELEMENTS
- CHECKS BEFORE START
- DAILY CHECKS
- CHECKING THE DEVICES
- B Starter Switch
- B Display Selector Switch
- B LCD Display for Normal Operation
- B Warning Lamp
- B LCD Display for Warning
- B Setting the Clock
- B Reordering the year/month/day and Changing the AM/PM System to the 24- hour One
- B Log Record
- B Periodic Check
- B If All the Check Points are not Displayed at a Glance on a Single Screen
- B When the Check-up is Completed
- B Horn Switch
- B Working Light Switch
- B AUX Port Flow Rate Limit Switch
- B Auto Idle Switch
- B Throttle Potentiometer
- B Travel Speed Switch
- CAB TYPE MACHINES
- AIR CONDITIONER
- HANDLING THE SAFETY DEVICES
- OPERATION OF THE ENGINE
- EXCAVATOR OPERATION
- RUNNING-IN OF THE NEW EXCAVATOR
- STARTING
- DRIVING
- TURNS
- UP AND DOWNHILL DRIVING
- PARKING ON A SLOPE
- OPERATION OF THE DOZER
- TWO PATTERN SELECTION SYSTEM(TPSS)
- OPERATION OF THE BOOM
- OPERATION OF THE ARM
- OPERATION OF THE BUCKET
- UNIT SWING AND BOOM SWING OPERATION
- AUXILIARY PORT OPERATION
- HOW TO RELEASE PRESSURE TRAPPED IN THE HYDRAULIC SYSTEM
- 1-way or 2-way CIRCUIT SELECTION VALVE OPERATION
- AUTO IDLE (AI) OPERATION
- IMPORTANT INFORMATION ON EXCAVATOR OPERATION
- TRANSPORTING THE EXCAVATOR ON A VEHICLE
- LIFTING OF THE EXCAVATOR
- MAINTENANCE
- MAINTENANCE INTERVALS
- OPENING AND CLOSING OF COVERS
- DAILY CHECKS
- B Checking Coolant Level
- B Checking Fuel Level
- B Checking Engine Oil Level
- B Checking Hydraulic Oil Level
- B Checking V-belt
- B Checking Radiator and Oil Cooler
- B Checking Washer Liquid
- B Cleaning Pre-Cleaner
- B Checking and Cleaning Engine and Electrical Wiring
- B Greasing Boom Swing Fulcrum
- B Washing Whole Machine
- B Greasing Front Attachments (without Bucket Pin and Boom Swing Fulcrum)
- B Greasing Bucket Pin and Bucket Link Pin
- REGULAR CHECKS AND MAINTENANCE WORK
- OTHER ADJUSTMENTS AND REPLACEMENTS
- TROUBLESHOOTING
- OPERATION UNDER COLD WEATHER CONDITIONS
- LONG STORAGE
- RECOMMENDED OILS
- APPENDICES
- LIFTING CAPACITY
- LIST OF SCREENS
CHECKS BEFORE START12
C Engine oil pressure low warning
When the engine oil pressure drops too low, the lamp
(red) starts flashing and the following message appears in
the display.
Immediately stop the engine and check the engine oil
level.
A If the starter key is turned to the "RUN" position
without running the engine and the oil lamp stays off,
then the hydraulic system may have failed.
If such occurs, immediately contact your local dealer
for repair.
C Various error warnings
If any components are detected to be in trouble, the
following message appears onscreen.
(See "LIST OF SCREENS" section)
Information
A " mark" may appear together with a warning
message.
If such occurs, the details can be checked by pressing the
information switch.
When contacting your local dealer for repair, notify them
of the information provided.
Example;
Press the information switch, and a detail such as shown
below appears.
A Press the information switch again, and the display
goes back to the previous screen.
(1) Oil lamp
(1) Information switch