OPERATOR'S MANUAL

PERIODIC SERVICE86
BChanging Front Axle Case Oil
1. Park the vehicle on a level surface.
2. Turn over the rubber sheet.
3. To drain the used oil, remove the drain plug and the
filling plug at the front axle case and drain the oil
completely into the oil pan.
4. After draining, reinstall the drain plug.
5. Fill with the new prescribed oil up to the upper line on
the dipstick.
(See the first table of "LUBRICANTS, FUEL AND
COOLANT" in "MAINTENANCE" section.)
6. After filling, reinstall the filling plug.
7. Properly dispose of used oil.
BReplacing Fuel Filter
Consult your local KUBOTA Dealer for this service.
EVERY 800 HOURS
BAdjusting Engine Valve Clearance
Consult your local KUBOTA Dealer for this service.
EVERY 1000 HOURS or EVERY 1 YEAR
BReplacing Air Cleaner Primary Element
and Secondary Element
(See "Cleaning Air Cleaner Primary Element" in "EVERY
100 HOURS" in "PERIODIC SERVICE" section.)
EVERY 1500 HOURS
BChecking Fuel Injection Nozzle Injection
Pressure
Consult your local KUBOTA Dealer for this service.
EVERY 2000 HOURS or EVERY 2 YEARS
Be sure to do the following service once every 2000 hours
or every 2 years whichever comes faster.
BFlushing Cooling System and Changing
Coolant
To avoid serious injury or death:
A Do not remove the radiator cap while coolant is
hot. When cool, slowly rotate cap to the first
stop and allow sufficient time for excess
pressure to escape before removing the cap
completely.
1. Stop the engine and let cool down.
2. Open the hood.
3. To drain the coolant, open the radiator drain plug and
remove radiator cap and engine coolant breather. The
radiator cap must be removed to completely drain the
coolant.
4. After all coolant is drained, close the drain plug.
5. Fill with clean water and cooling system cleaner.
6. Follow directions of the cleaner instruction.
7. After flushing, fill with clean distilled water and anti-
freeze until the coolant level is just below the radiator
cap.
Install the radiator cap securely.
8. Fill with fresh distilled water up to the "FULL" mark on
the recovery tank.
9. Close the engine coolant breather.
10.Start and operate the engine for few minutes.
11.Stop the engine and let cool.
12.Check coolant level of recovery tank and add coolant
if necessary.
Oil capacity 0.6 L (0.6 U.S.qts.)
(1) Drain plug
(2) Filling plug with dipstick
(A) Oil level is acceptable
within this range
Coolant capacity 7.9 L (8.3 U.S.qts.)