OPERATOR'S MANUAL
Table Of Contents
23OPERATING THE VEHICLE
BCoolant Temperature Gauge
To avoid serious injury or death:
A Do not remove radiator cap until coolant and
engine temperature has cooled. Then loosen
cap slightly to the stop to relieve any pressure
before removing cap completely.
1. With the key switch "ON" the coolant temperature
gauge indicates the temperature of the coolant.
2. If the engine is overheated, the warning lamp will come
on and the buzzer will sound. Check the vehicle by
referring to "TROUBLESHOOTING" section.
A If the engine overheat and VHT overheat occur
together, do not stop the engine. When it is safe to do
so, remove the engine load and keep the engine idling
to allow cool down to occur.
After the warning lamps go off, wait for 5 minutes, and
stop the engine.
See "TROUBLESHOOTING" section.
BHourmeter and Odometer
When the key is turned to the "ON" position and the
engine is not running, the hourmeter is displayed.
When the key is the "ON" position and the engine is
running, the odometer is displayed.
The hourmeter indicates in 5 digits the hours the vehicle
has been used; the last digit indicates 1/10 of an hour.
The odometer indicates in 5 digits the distance the vehicle
has been used; the last digit indicates 1/10 of a mile.
(1) Coolant temperature gauge
(2) Overheat warning lamp
(1) Hourmeter
(1) Odometer