OPERATOR'S MANUAL
Table Of Contents
- OPS - Excavator U48-4 (RD45881312)
- Abbreviation List
- General Symbols
- Foreword
- Safety First
- Contents Page
- Safe Operation
- Dealer Service
- Technical Data
- Description of Machine Parts
- Instrument Panel and Control Elements
- Checks Before Start
- Daily Checks
- Checking the Devices
- Starter Switch
- Display Selector Switch
- LCD Display for Normal Operation
- Warning Lamp
- LCD Display for Warning
- Setting the Clock
- Reordering the year/month/day and Changing the AM/PM System to the 24 hour one
- Log Record
- Periodic Check
- If all the Check Points are not Displayed at a Glance on a Single Screen
- When the Checkup is Completed
- Horn Switch
- Working Light Switch
- AUX Port Flow Rate Limit Switch
- Auto Idle Switch
- Throttle Potentiometer
- Travel Speed Switch
- CAB Type Machines
- Air Conditioner
- Handling the Safety Devices
- Operation of the Engine
- Excavator Operation
- Running-In of the New Excavator
- Starting
- Driving
- Turns
- Up and Downhill Driving
- Parking on a Slope
- Operation of the Dozer
- Two Pattern Selection System (TPSS)
- Operation of the Boom
- Operation of the Arm
- Operation of the Bucket
- Unit Swing and Boom Swing Operation
- Auxiliary Port Operation
- How to Release Pressure Trapped in the Hydraulic System
- 1 Way or 2 Way Circuit Selection Valve Operation
- Auto Idle (AI) Operation
- Important Information on Excavator Operation
- Transporting the Excavator on a Vehicle
- Lifting of the Excavator
- Maintenance
- Maintenance Intervals
- Opening and Closing of Covers
- Daily Checks
- Checking Coolant Level
- Checking Fuel Level
- Checking Engine Oil Level
- Checking Hydraulic Oil Level
- Checking V-Belt
- Checking Radiator and Oil Cooler
- Checking Washer Liquid
- Cleaning Pre-Cleaner
- Checking and Cleaning Engine and Electrical Wiring
- Greasing Boom Swing Fulcrum
- Washing Whole Machine
- Greasing Front Attachments (without Bucket Pin and Boom Swing Fulcrum)
- Greasing Bucket Pin and Bucket Link Pin
- Regular Checks and Maintenance Work
- Other Adjustments and Replacements
- Troubleshooting
- Operation Under Cold Weather Conditions
- Long Storage
- Recommended Oils
- Appendices
- Lifting Capacity
- List of Screens
CHECKS BEFORE START20
BCab Light Switch
To turn on the cab light, set the starter switch to the "RUN"
position and then the cab light switch to the "ON" position,
respectively.
BHeater Switch
Turn the starter switch to the "RUN" position and turn the
heater switch clockwise, the heater fan will be activated
and the cabin will start to warm up. The heater has three
position.
A During summer, turn the heater valve clockwise to
close the valve.
BOpening/Closing of CAB Door
1. Unlock the CAB door and pull the knob. Open the CAB
door fully until fixed into place.
2. To close the CAB door, push the release lever down
and close the door.
3. When leaving the excavator, always lock the door.
(1) Cab light switch
(1) Heater switch
(2) Temperature control dial
(1) Door knob (outside)
(1) Release lever
(2) Door knob (inside)