OPERATOR'S MANUAL
Table Of Contents
- OPS - Utility Vehicle RTV1140CPX (K7611-7121-5)
- Abbreviation List
- Introduction
- Universal Symbols
- Foreword
- Safety First
- Contents Page
- Safe Operation
- Servicing of Vehicle
- Specifications
- Vehicle Limitations
- Instrument Panel and Controls
- Pre-Operation Check
- Operating the Engine
- Operating the Vehicle
- Seating and Cargo Bed
- Tires and Wheels
- Towing and Transporting
- Maintenance
- Periodic Service
- How to Open the Hood and Tilt the Seat
- How to Raise the Carbo Bed
- Jack Up Point
- Daily Check
- Walk Around Inspection
- Checking and Refueling
- Checking Engine Oil Level
- Checking Hydraulic Tank Oil Level
- Checking Transmission Fluid Level
- Checking Coolant Level
- Cleaning Radiator Screen
- Checking Brake Fluid Level
- Checking Brake Pedal
- Checking Parking Brake
- Checking Gauges, Meter and Easy Checker
- Checking Head Light, Turn Signal Light etc
- Checking Seat Belt and ROPS
- Checking Joint Boot
- Checking Tire Inflation Pressure
- Checking Backup Beeper
- Every 50 Hours
- Every 100 Hours
- Every 200 Hours
- Changing Engine Oil
- Adjusting Parking Brake
- Replacing Engine Oil Filter
- Replacing Transmission Oil Filter - HST
- Replacing Transmission Oil Filter - Suction
- Changing Hydraulic Tank Oil
- Checking Brake Pedal
- Checking Brake Hose and Pipe
- Checking Front Brake Case
- Checking Brake Light Switch
- Checking Radiator Hose and Clamp
- Checking Power Steering Line
- Checking Intake Air Line
- Every 300 Hours
- Every 400 Hours
- Every 500 Hours
- Every 800 Hours
- Every 1500 Hours
- Every 3000 Hours
- Every 1 Year
- Every 2 Years
- Every 4 Years
- Service As Required
- Storage
- Troubleshooting
- Options
- Index
SAFE OPERATION-4
1. Disengage power to attachment(s) when transporting
or not in use.
2. Do not tow this vehicle. Use a suitable truck or trailer
when transporting on public roads.
3. Use extra care when loading or unloading the vehicle
into a trailer or truck.
Before servicing the vehicle, park it on a firm, flat and level
surface, set the parking brake, lower all implements to the
ground, place the range gear shift lever in neutral, stop the
engine and remove the key.
1. Allow the vehicle time to cool off before working on or
near the engine, muffler, radiator, etc.
2. Always stop the engine before refueling. Avoid spills
and overfilling.
3. Do not smoke when working around battery or when
refueling. Keep all sparks and flames away from
battery and fuel tank. The battery presents an
explosive hazard, because it gives off hydrogen and
oxygen especially when recharging.
4. Before "jump starting" a dead battery, read and follow
all of the instructions. (See "JUMP STARTING" in
"OPERATING THE ENGINE" section.)
5. Keep first aid kit and fire extinguisher handy at all
times.
6. Disconnect the battery's ground cable before working
on or near electric components.
7. To avoid the possibility of battery explosion, do not use
or charge the refillable type battery if the fluid level is
below the LOWER (lower limit level) mark. Check the
fluid level regularly and add distilled water as required
so that the fluid level is between the UPPER and
LOWER marks.
8. To avoid sparks from an accidental short circuit,
always disconnect the battery's ground cable (-) first
and reconnect it last.
9. Do not remove radiator cap while coolant is hot. When
cool, slowly rotate cap to the first stop and allow
sufficient time for excess pressure to escape before
removing the cap completely. If the vehicle has a
coolant recovery tank, add coolant or water to the tank,
not the radiator. (See "Checking Coolant Level" in
"DAILY CHECK" in "PERIODIC SERVICE" section.)
10.Do not attempt to mount a tire on a rim. This should be
done by a qualified person with the proper equipment.
11.Always maintain the correct tire pressure. Do not
inflate tires above the recommended pressure shown
in the operator's manual.
12.Securely support the vehicle when changing wheels.
13.Make sure that wheel bolts have been tightened to the
specified torque.
14.Do not work under any hydraulically supported
devices. They can settle, suddenly leak down, or be
accidentally lowered. If it is necessary to work under
the vehicle or any vehicle elements for servicing or
adjustment, securely support them with stands or
suitable blocking beforehand.
(1) Parking brake lever
5. TRANSPORTING
6. SERVICING THE VEHICLE
(1) Battery