OPERATOR'S MANUAL
Table Of Contents
- OPS - Utility Vehicle RTV1140CPX (K7611-7121-5)
- Abbreviation List
- Introduction
- Universal Symbols
- Foreword
- Safety First
- Contents Page
- Safe Operation
- Servicing of Vehicle
- Specifications
- Vehicle Limitations
- Instrument Panel and Controls
- Pre-Operation Check
- Operating the Engine
- Operating the Vehicle
- Seating and Cargo Bed
- Tires and Wheels
- Towing and Transporting
- Maintenance
- Periodic Service
- How to Open the Hood and Tilt the Seat
- How to Raise the Carbo Bed
- Jack Up Point
- Daily Check
- Walk Around Inspection
- Checking and Refueling
- Checking Engine Oil Level
- Checking Hydraulic Tank Oil Level
- Checking Transmission Fluid Level
- Checking Coolant Level
- Cleaning Radiator Screen
- Checking Brake Fluid Level
- Checking Brake Pedal
- Checking Parking Brake
- Checking Gauges, Meter and Easy Checker
- Checking Head Light, Turn Signal Light etc
- Checking Seat Belt and ROPS
- Checking Joint Boot
- Checking Tire Inflation Pressure
- Checking Backup Beeper
- Every 50 Hours
- Every 100 Hours
- Every 200 Hours
- Changing Engine Oil
- Adjusting Parking Brake
- Replacing Engine Oil Filter
- Replacing Transmission Oil Filter - HST
- Replacing Transmission Oil Filter - Suction
- Changing Hydraulic Tank Oil
- Checking Brake Pedal
- Checking Brake Hose and Pipe
- Checking Front Brake Case
- Checking Brake Light Switch
- Checking Radiator Hose and Clamp
- Checking Power Steering Line
- Checking Intake Air Line
- Every 300 Hours
- Every 400 Hours
- Every 500 Hours
- Every 800 Hours
- Every 1500 Hours
- Every 3000 Hours
- Every 1 Year
- Every 2 Years
- Every 4 Years
- Service As Required
- Storage
- Troubleshooting
- Options
- Index
-13SAFE OPERATION
1. Keep danger, warning and caution labels clean and free from obstructing material.
2. Clean danger, warning and caution labels with soap and water, dry with a soft cloth.
3. Replace damaged or missing danger, warning and caution labels with new labels from your local KUBOTA Dealer.
4. If a component with danger, warning and caution label(s) affixed is replaced with new part, make sure new label(s)
is(are) attached in the same location(s) as the replaced component.
5. Mount new danger, warning and caution labels by applying on a clean dry surface and pressing any bubbles to outside
edge.
8. CARE OF DANGER, WARNING AND CAUTION LABELS