OPERATOR'S MANUAL
Table Of Contents
- OPS - Utility Vehicle RTV1140CPX (K7611-7121-5)
- Abbreviation List
- Introduction
- Universal Symbols
- Foreword
- Safety First
- Contents Page
- Safe Operation
- Servicing of Vehicle
- Specifications
- Vehicle Limitations
- Instrument Panel and Controls
- Pre-Operation Check
- Operating the Engine
- Operating the Vehicle
- Seating and Cargo Bed
- Tires and Wheels
- Towing and Transporting
- Maintenance
- Periodic Service
- How to Open the Hood and Tilt the Seat
- How to Raise the Carbo Bed
- Jack Up Point
- Daily Check
- Walk Around Inspection
- Checking and Refueling
- Checking Engine Oil Level
- Checking Hydraulic Tank Oil Level
- Checking Transmission Fluid Level
- Checking Coolant Level
- Cleaning Radiator Screen
- Checking Brake Fluid Level
- Checking Brake Pedal
- Checking Parking Brake
- Checking Gauges, Meter and Easy Checker
- Checking Head Light, Turn Signal Light etc
- Checking Seat Belt and ROPS
- Checking Joint Boot
- Checking Tire Inflation Pressure
- Checking Backup Beeper
- Every 50 Hours
- Every 100 Hours
- Every 200 Hours
- Changing Engine Oil
- Adjusting Parking Brake
- Replacing Engine Oil Filter
- Replacing Transmission Oil Filter - HST
- Replacing Transmission Oil Filter - Suction
- Changing Hydraulic Tank Oil
- Checking Brake Pedal
- Checking Brake Hose and Pipe
- Checking Front Brake Case
- Checking Brake Light Switch
- Checking Radiator Hose and Clamp
- Checking Power Steering Line
- Checking Intake Air Line
- Every 300 Hours
- Every 400 Hours
- Every 500 Hours
- Every 800 Hours
- Every 1500 Hours
- Every 3000 Hours
- Every 1 Year
- Every 2 Years
- Every 4 Years
- Service As Required
- Storage
- Troubleshooting
- Options
- Index
PERIODIC SERVICE68
EVERY 300 HOURS
BChecking Tire
1. Check to see if tires are not damaged.
2. If the tires are cracked, bulged, or cut, or they are worn
out, replace or repair them at once.
C Tire Tread Depth
Always replace the tires when the tread depth is worn to
minimum allowable.
EVERY 400 HOURS
BChanging Knuckle Case Oil
1. Park the vehicle on a firm, flat and level surface.
2. Remove the tire.
3. To drain the used oil, remove the drain and filling plugs
at the LH knuckle case and drain the oil completely
into the oil pan.
4. After draining, reinstall the drain plug.
5. Fill with the new oil up to the filling port level.
(See "LUBRICANTS, FUEL AND COOLANT" in
"MAINTENANCE" section.)
6. After filling, reinstall the filling plug.
7. Use the same procedure to change the RH knuckle
case oil.
(A) 3 mm (0.12 in.)
Oil capacity (one side) Ref. 0.15 L (0.16 U.S.qts.)
(1) Drain plug
(2) Filling plug