OPERATOR'S MANUAL
Table Of Contents
- OPS - Utility Vehicle RTV1140CPX (K7611-7121-5)
- Abbreviation List
- Introduction
- Universal Symbols
- Foreword
- Safety First
- Contents Page
- Safe Operation
- Servicing of Vehicle
- Specifications
- Vehicle Limitations
- Instrument Panel and Controls
- Pre-Operation Check
- Operating the Engine
- Operating the Vehicle
- Seating and Cargo Bed
- Tires and Wheels
- Towing and Transporting
- Maintenance
- Periodic Service
- How to Open the Hood and Tilt the Seat
- How to Raise the Carbo Bed
- Jack Up Point
- Daily Check
- Walk Around Inspection
- Checking and Refueling
- Checking Engine Oil Level
- Checking Hydraulic Tank Oil Level
- Checking Transmission Fluid Level
- Checking Coolant Level
- Cleaning Radiator Screen
- Checking Brake Fluid Level
- Checking Brake Pedal
- Checking Parking Brake
- Checking Gauges, Meter and Easy Checker
- Checking Head Light, Turn Signal Light etc
- Checking Seat Belt and ROPS
- Checking Joint Boot
- Checking Tire Inflation Pressure
- Checking Backup Beeper
- Every 50 Hours
- Every 100 Hours
- Every 200 Hours
- Changing Engine Oil
- Adjusting Parking Brake
- Replacing Engine Oil Filter
- Replacing Transmission Oil Filter - HST
- Replacing Transmission Oil Filter - Suction
- Changing Hydraulic Tank Oil
- Checking Brake Pedal
- Checking Brake Hose and Pipe
- Checking Front Brake Case
- Checking Brake Light Switch
- Checking Radiator Hose and Clamp
- Checking Power Steering Line
- Checking Intake Air Line
- Every 300 Hours
- Every 400 Hours
- Every 500 Hours
- Every 800 Hours
- Every 1500 Hours
- Every 3000 Hours
- Every 1 Year
- Every 2 Years
- Every 4 Years
- Service As Required
- Storage
- Troubleshooting
- Options
- Index
69PERIODIC SERVICE
BChanging Transmission Fluid
To avoid personal injury:
A Be sure to stop the engine before changing the
oil.
A Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Park the vehicle on a flat surface, raise the cargo bed,
mount the safety support.
2. To drain the used oil, remove the drain plug at the
bottom of the transmission case and drain the oil
completely into the oil pan.
3. After draining, reinstall the drain plug.
4. Fill with the new KUBOTA SUPER UDT fluid up to the
upper notch on the dipstick.
(See "LUBRICANTS, FUEL AND COOLANT" in
"MAINTENANCE" section.)
5. After running the engine for a few minutes, stop the
engine and check the oil level again; add oil to
prescribed level.
A Do not operate the vehicle immediately after changing
the transmission fluid.
Run the engine at medium speed for a few minutes to
prevent damage to the transmission.
Oil Capacity 12 L (3.2 U.S.gals.)
(1) Oil inlet
(2) Gauge
(A) Oil level is acceptable within this range
(1) Drain plug