Installation manual
STEP 12 CONNECT DRAIN LINE
FOLLOW ALL LOCAL CODES
AND ORDINANCES
The drain hose molded end will fit 5/8”(15.9mm),
3/4”(19.1mm) or 1”(25mm)diameter connections
on the air gap, waste tee or disposer. Cut the
marked line as required for your installation.
• If a longer drain hose is required, add up to 42”
(1067mm) length for a total of 10ft.(3.05mm) to
the factory installed hose. Use 5/8”(15.9mm)
or 7/8”(22M) inside diameter hose and a coupler
to connect two hose ends.. Secure the connection
with hose clamps.
• Secure the drain hose to the air gap, waste
tee or disposer with clamps.
NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED
10 FEET FOR PROPER DRAIN OPERATION.
DRAIN LINE INSTALLATION
• Connect drain line to air gap, waste tee or disposer
using either of the previously determined method.
Method 1 - Air gap with waste tee or disposer
Method 2 - High drain loop with waste tee or disposer
IMPORTANT -
When connecting the drain line to
the disposer, check to be sure that
the drain plug has been removed.
DISHWASHER WILL NOT DRAIN IF
PLUG IS LEFT IN PLACE.
TIP: Avoid unnecessary service call charges. Always
be sure disposer drain plug has been removed before
attaching dishwasher drain hose to dispenser.
10
32”(812.8mm)
18”(457mm)
32”(812.8mm)
18”(457mm)
Installation Instructions