Installation Guide and User Manual

INSTALLING THE RANGE TOP
- Remove the range top from its package and set aside all burners, burner caps and grates.
- Gently slide in the cook top in to the cut-out, make sure your cut-outs are there for the
gas connection and electrical hookup(if you choose to use it).
- Once this is done you’re now ready to slide the range top all the way back to the wall.
- Install all burners and burner caps.
- Install all grates.
CONNECTING GAS TO RANGE TOP
This range top is designed to operate at a pressure of 4”of water column on natural gas or
10”of water column on propane gas (LPG).
Make sure you are supplying your range top with the type of gas for which it is designed.
It’s shipped for use with NG. This range top is convertible for use on natural gas (LPG)
also. When using this range top on LPG gas, conversion must be made by a qualified LPG
installer before attempting to operate the range top on that gas.
For correct operation, the pressure of natural gas supplied to the regulator should be
between 4”and 5”of water column. For LP gas, the pressure supplied must be between
10”and 12”of water column.
When checking for correct operation of the regulator, the inlet pressure must beat least
1”more than the operating manifold pressure as given above.
The pressure regulator located at the inlet of the range top manifold must remain in the
supply line regardless of whether Natural(NG)or Propane(LP)gas is being used.
A flexible metal appliance connect or used to connect the range top to the gas supply
should be 3 feet/91.4 cm max. in length for easy installation. In Canada, flexible connectors
should be single wall metal connectors less than 6 feet/182.9 cm in length.
Shut o the main gas supply valve before removing the old cooking appliance(if
applicable)and leave it of fun till the new hook-up has been completed. Don’t forget to
relight the pilots on other gas appliances when you turn the gas back on.
Because hard piping restricts movement of the range top, the use of a CSA certified
flexible metal appliance connector is recommended unless local codes require a
hard-piped connection. Never reuse an old connect or when installing a new range top.If
the hard piping method is used, you must carefully align the pipe.
13