Installation Guide and User Manual

The installation of range tops designed for recreational vehicle installation must conform
with state or other codes or, in the absence of such codes, with the Standard for recreational
vehicles. ANSIA 119.2.2–1982 in the U.S.A. or CAN/CGA Z240.4.2 in Canada.
The installation of appliances designed for recreational park trailers must conform with state
or other codes or, in the absence of such codes, with the standard for recreational park
trailers, ANSIA119.5.
Note: Check all piping connections in the unit for leaks. Never use an open flame to check
for gas leaks. Use a soap solution, 75% water, 25% dishwashing soap. It is possible for
connections made at the factory to leak, due to vibration encountered in transportation.
Make certain you have checked them all, and repair any connections that leak.
The appliance and its individual shut-o valve must be disconnected from the gas supply
piping system during any pressure testing of that system attest pressures in excess
of ½ psig.
The appliance must be isolated from the gas supply piping system by closing its individual
manual shut-o valve during any pressure testing of the gas supply piping system at test
pressures equal to or less than 1/2 psig.
All units must be installed in accordance to minimum rear and side wall clearances and
clearances extended vertically above cooking top which are state don the serial plate (the
serial plate is located on the back of the unit.)
Make sure that the wall coverings, counter tops and cabinets around the range top can with
stand temperatures of up to 200˚F/93˚C generated by the range top.
Gas line shut-o valve
To reduce the possibility of gas leaks, apply Teflon tape or a thread
compound approved for use with LP or Natural gases to all
threaded connections.
Connect the supplied ½” threaded pipe to the units regulator
located on the back left of the unit. We suggest using a ½” female
to 3/8” male fl are adapt or on the end of the½”threaded pipe
supplied.
Use a 5/8” flexible appliance connect or to connect your gas supply
to the appliance. A 3 foot length this recommended for ease of
installation but other lengths are acceptable. Never use an old
connector when installing a new range.
Check for leaks using a leak detector or soapy water, 75%
water, 25% dishwashing soap.
CLEARANCES
6