Dimensions Guide

U
.
S
.
&
C
A
N
A
D
A
-
2
Y
E
A
R
S
W
A
R
R
A
N
T
Y
F
O
R
P
A
R
T
S
A
N
D
L
A
B
O
R
Troubleshooting
Before you call for service, please review the potential problem / possible causes and
remedies shown in the table below.
Nothing works
Oven is not connected to the electrical
power.
Power supply is not energized.
Have oven connected to a properly
sized electrical power supply by a
qualified electrician.
Have an electrician check the power
supply, including the house circuit
breaker, wiring and fuses
Top burners do not
light or do not burn
evenly
Plug on range is not completely inserted
in the electrical outlet.
Burner holes on the side of the burner
may be clogged.
Make sure the unit is properly
co
nnected to the power supply
Remove the burner heads and clean
them. Check the electrode area for
burned-on food or grease.
Burner flames very
large and yellow.
Burner bezel ports are clogged.
Burner ports or burner caps are not
positioned properly.
Cooktop is being operated with the
wrong type of gas.
Regulator is not installed, is faulty, or is
set for the wrong type of gas.
Clean burner bezel ring ports with
straightened paper clip, needle, or wire.
Remove
and carefully re-install burner
bezel and caps.
Ensure that the type of cooktop matches
the natural gas supply.
Check installation, replace regulator, or
set regulator for proper gas.
Sparking but no
flame ignition.
Gas shut-o valve is in the ‘OFF’
position.
Turn shut-o valve to the ‘ONposition.
Igniters spark
continuously after
flame ignition.
Power supply polarity is reversed.
Igniters are wet or dirty.
Have polarity corrected.
Dry or clean igniters.
Burner flame goes
out at lo
w setting.
Low gas supply pressure.
Air intake holes around knobs are
obstructed.
Contact gas company.
Remove obstruction.
Oven will not heat Oven settings are not corrected
Follow mode selection and clock
settings as specified in Oven Operation
section of the manual.
Foods over-cooked
or under-cooked
Incorrect cooking time or temperature.
Adjust time, temperature, or rack
position.
‘Cracking’ or
‘Popping’ sound.
This is the sound of metal heating and
cooling.
This is normal.
27
FOR MORE DETAILS AND INFORMATION, PLEASE VISIT OUR WEBSITE
WWW.KUCHT.COM
27