Instructions / Assembly

UNIVERSAL RACK ASSEMBLY
INSTRUCTIONS
1. Insert long U-bar (part #1) and short
U-bar (part #2) into plastic sleeve (part
#3) with flat side facing upward as
shown in the diagram - make sure to
line up holes on all parts.
2. Align iron plate (part #4) with plastic
sleeve. Insert short bolts (part #10)
through each of the four corners of
sleeve and through plate. Secure using
washer (part #11) and self locking nut
(part#9) under the sleeve, tighten.
3. Insert mounting bolt (part #6)
through remaining holes and position
rack on cross bars (not included),
attach iron bracket (part #5), use ring
nut/knob (part #8) to secure.
Completely tighten all bolts and knobs.
*Kit contains set of (4) 3" and (4) 2.5" mounting bolts for your convenience. Select the set length that best fits
your vehicle.
Contains 2 Ratchet straps. To trim the straps, wrap masking tape around the area you
wish to cut. Using a sharp knife or scissors, cut through the tape. Remove tape carefully
and singe frayed ends with a lighter.
201610