Instructions / Assembly

Greasing

In order to protect the moving spare parts and keep them in good condition, apply grease

regularly by using a grease gun at the fitting positions above.

Cleaning and Adjusting Spark Plug BR6HS

You should periodically remove and inspect the spark plug because heat and deposits will cause the

spark plug to slowly break down and erode. If necessary, replace the spark plug with another of the

correct type. Before fitting the spark plug, measure the electrode gap with a wire thickness gauge adjust

the gap to 0.6 – 0.7mm.

When fitting the plug, always clean the gasket surface and use a new gasket. Wipe off any dirt from the

threads and screw in the spark plug to the correct torque.

Checking the Fuel System

Check the fuel lines for leaks, crack, or malfunction.

Repair it immediately, if necessary.

Check for fuel leakage regularly

Inspecting Idling Speed

A diagnostic tachometer should be used for this procedure. Results may vary depending on whether

testing is conducted with the flushing attachment, in a test tank, or with the outboard motor in the water.

1. Start the engine and allow it to warm up fully in neutral until it is running smoothly.