Instructions / Assembly

ITEM # MOTOR25

2.6 HP OUTBOARD MOTOR

SPECIFICATIONS:

4-Stroke Outboard Motor

2.6 HP @ 5,500 RPM

Adjustable Steering Friction

Full Throttle RPM Range: 5,250-5,750

Displacement: 72 cc

Engine type: 1 Cylinder

Bore & Stroke: 2.13" x 1.24"

Compression Ratio: 9.0:1

Fuel/Induction System: SOHV

Intake: Carburetor

Exhaust: Above Propeller

Cooling: Water / Thermostatic Control

Ignition System: CDI

Starting System: Manual recoil-start only. (A battery is not available.)

Lubrication: Splash

Gear Ratio: (27:12) 2.25:1

Gear Shift: Forward-Neutral

Shaft Length: 17"

Tilt Up Angle: 80°

Degree of Trim: 4 Positions

Steering Angle: 360°

Oil Capacity: 11.84 ounces (SAE10W30)

Fuel Capacity: 0.32 Gallon (40.5 ounces) Unleaded Gasoline

Spark Plug: BR6HS

Spark Plug Gap: 0.6～0.7 mm

EPA Approved

Includes: Tool Set

High Altitude Use: This outboard motor is not recommended for high altitude use above

3,000 ft. If you are using this motor above sea level, it may not function properly because

of air flow getting through the carburetor.

If a title is required for your state, contact us for a Certificate of Origin.

A remote control box (side mount type) is not available.

Transport and store vertically on an engine stand in an upright position. Keep the motor

trimmed or tilted down, especially if it’s outdoors. This will allow all of the water to drain out

of the motor’s cooling system. If it’s tilted up, some water may remain in the motor, where it

can freeze and cause a cracked block or a ruined water pump housing.