Instructions / Assembly

6
Improper mounting of the outboard motor could result in hazardous conditions. For permanently mounted
models, your dealer or other person experienced in proper rigging should mount the motor. If you are
mounting the motor yourself, you should be trained by an experienced person. For portable models, your
dealer or other person experienced in proper outboard motor mounting should show you how to mount
your motor.
The information presented in this section is intended as reference only. Proper mounting depends in part
on experience and the specific boat and motor combination.
The mounting height of the outboard motor greatly affects your
boat running efficiency. If the mounting height is too high, cavitation
tends to occur, thus reducing the propulsion. If the mounting height
is too low, the water resistance will increase and thereby reduce
engine efficiency. Mount the outboard motor so that the anti-cavitation
plate is between the bottom of the boat and a level 25mm below it.
The optimum mounting height of the outboard motor is
affected by the boat and motor combination and the desired
use. Test runs at a different height can help determine the
optimum mounting height.
Clamping The Outboard Motor
1. Tighten the transom clamp screw evenly and securely.
Occasionally check the clamp screws for tightness during
operation of the outboard motor because they could
become loose due to engine vibration.
Loose clamp screws could allow the outboard motor to fall
off or move on the transom. This could cause loss of control.
Make sure the clamp screws are tightened securely. Occasionally check the screws for tightness during
operation.