Installation Instructions Application Coding Interface v1.2 (20.08.2019) Kufatec GmbH & Co. KG - Dahlienstr. 15 - 23795 Bad Segeberg - e-mail: info@kufatec.
Contents 1 Liability Exclusion 3 2 Copyright 4 3 General notes 4 4 Safety Instructions 5 5 Requirements for the intended use 5 6 Installation Instruction 6 7 Using the coding interface 7 8 Note additional vehicle function 8 9 Bus rest 8 Kufatec GmbH & Co. KG - Dahlienstr. 15 - 23795 Bad Segeberg - e-mail: info@kufatec.
1 Liability Exclusion Dear Customer, Our cable sets are developed according to the connection- and circuit diagrams of the corresponding car manufacturers. Before the serial production, the cable sets will be adjusted and tested on an original vehicle. Therefore, the integration into the vehicle electronics follows the guidelines provided by the car manufacturer.
2 Copyright Our installation and operation instructions, installation plans, software and other written and/or pictured documentations are protected by copyright. The publication or distribution of these documentations is only permitted with a written approval of Kufatec GmbH & Co. KG. 3 General notes While developing this product, your personal safety combined with the best operating service, modern design and an up-to-date production technique was especially taken into account.
4 Safety Instructions The installation should only be performed by trained personnel. Only perform installations while in a voltage-free state. For example, disconnect the battery. Please pay attention to the instructions provided by the manufacturer. • Never use bolts or nuts form the car’s safety devices for installation. If bolts or nuts form the steering wheel, brakes or other safety devices are used for installation of the device, it may cause an accident.
Installation Instruction The following illustration shows the cable routing as well as the position of the individual components: 1 1 Figure 1: Vehicle overview • 1 Connection coding interface Kufatec GmbH & Co. KG - Dahlienstr. 15 - 23795 Bad Segeberg - e-mail: info@kufatec.
Using the coding interface 1 2 2 3 3 Figure 2: Using the coding interface No. !! 1 2 3 Table 1: Instructions to use the coding interface Work step Important note: For the models from model year 2019 (VW, Audi, Skoda, Seat) - the bonnet must be opened before coding. It must remain open during the coding process. Turn on the ignition. Please note that the engine will not be started. Wait approx. 30 seconds and plug the interface into the diagnostic interface (OBD II plug) of the vehicle.
Note additional vehicle function Note additional vehicle function • Note: If the dongle offers/activates additional vehicle functions, check the vehicle’s documents for the particular operation. 9 Bus rest Final work / bus rest • Important note: After the coding has been completed, you need to wait for the bus rest. • Proceed as follows: - Switch off ignition and close all doors. - Close up the car by remote control. - Leave the car for about 10 minutes.
List of Figures 1 2 Vehicle overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Using the coding interface . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 7 List of Tables 1 Instructions to use the coding interface . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Kufatec GmbH & Co. KG - Dahlienstr. 15 - 23795 Bad Segeberg - e-mail: info@kufatec.
