Instruction Manual

13 Connection CAN high + low / ground / push button
1
2
3
2
4
5
Figure 6: Connection CAN high + low / ground / push button
Table 4: Instructions for the connection CAN high + low / ground / push button
No. Work step Note
1 The fuse box is located under the front foot tray.
2 Remove the red plug (CAN-bus) out of the plug-in connection and pull it downwards.
Please connect CAN high + CAN low with the red plug as follows:
CAN high (black/whi te) to the black cable Pin 1
CAN low (black/yellow) to the orange/brown cable Pin 2
If the prov i de d cable set consi st s exc lu si vely of grey wires, connect the cables ac-
cording to the wire inscription at the end of the cable.
3 Place the cable for ignition lead (red/white) in a free fuse spot and prote ct the spot
with a 20 ampere fuse afterwards. Pl ease measure with a mult i met e r, on which
fuse spot ignition lead is placed.
4 Connect the ground cable (brown) with the marked ground spot.
Connect the control unit as well as the module with the cable set and place it behin d
the dashboard carrier with cable ties respectively.
5 Please drill a hole for the push button at the marked position and install the button
at that position afterwards.
7mm
Kufatec GmbH & Co. KG - Dahlienstr. 15 - 23795 Bad Segeberg - e-mail: [e-mail] 12