Version 1.03 (01.06.2017) Installation Instructions Complete set Active Sound incl. Soundbooster Golf 7 GTD Item no. 40626 www.kufatec.de Kufatec GmbH & Co. KG • Dahlienstr. 15 • 23795 Bad Segeberg • e-mail: info@kufatec.
Contents Liability Exclusion .....................................................................................................................................2 Copy Right ...............................................................................................................................................3 General Notes ..........................................................................................................................................3 Safety Instructions ..................
Liability Exclusion Dear Customer, our cable sets are developed according to the connection- and circuit diagrams of the corresponding car manufacturer. Before the original production the cable sets will be tested on an original car. Therefore, the integration into the car electronics will be executed according to the instructions of the manufacturer.
Copy Right Our installation- and removal instructions, installation plans, software and other documentation with texts or pictures are protected by copy right. A publication or distribution of these documents is only permitted with a written approval of Kufatec GmbH & Co. KG. General Notes Regarding the development there has especially been paid attention to your personal safety together with the most possible operating comfort, modern design and actual product technologies.
Safety Instructions The installation may only be executed by trained qualified personnel. Please execute the installations only in a condition of dead voltage. Here please separate for example the battery from the main power supply and consider the instructions of the car manufacturer. • In order to not endanger your own driving safety please never use security relevant screws, bolts or other fixation pieces at steering, brake system or other components.
Notes NOTE: The use of a sound booster is not permitted without registration in the vehicle papers, in the area of the german StVZO. The noise emission of the vehicle is increased by this retrofit. The regulations of the StVZO must be observed. It is therefore recommended to ask for a specific registration option at the responsible TÜV/DEKRA office before retrofitting. Outside Germany, please observe the laws on vehicle licensing applicable in your country.
Assembly Instructions The following illustration shows the cable routing as well as the position of the individual components.
Remove the trim panels from the ceiling at the area of the c-pillar, fig. 1. In the next step loosen the trim panel of the c-pillar on the left driver’s side, which is attached by clips, fig. 2. Fig.. 1 Fig. 2 The control unit for the sound generator is located behind the trim panel of the c-pillar, fig. 3. Please pull the plug off from the control unit for the sound generation, according to the arrow, fig. 4. Fig. 3 Fig.
Please connect the delivered cable set by connecting the plug of the cable set (fig. 5) to the control unit for the sound generation. Afterwards connect the plug you have removed before with the coupling of the cable set, fig. 5 + 6. Fig. 5 Fig. 6 The assembly of the Sound Booster Pro Module takes place right beside the control unit in the c-pillar, fig. 7. Please fix the module and the cable set with appropriate installation material. Fig.
Optionally, the pushbutton for switching the sound profiles, fig. 8, can be installed below the dashboard, at the driver’s side, fig. 9. Fig. 8 Fig. 9 Route the cables along the sill trim to the a-pillar and onwards to the dashboard. Fig. 10 Fig.
To change between active or passive operating mode, select the driver profile (pushbutton) or use the Driving Mode Selection menu, fig. 12. For this, choose in Individual mode the option Sport, fig. 13. Fig. 12 Fig. 13 The reassembly is made in reversed order. See to a CAN bus sleep mode of at least 10 minutes (lock vehicle). Thereafter the installation is completed. You can switch the sound profiles with the pushbutton. You can choose between 3 sound profiles.
