Instruction Manual

11 Remote Control Programming
1
2
3
Figure 4: Remote Control Programm i ng
Table 3: Instruction for the Programming of the Remote Control
No Procedure Note
1 The deli vered remote control is paired together with the receiver, so that you can
use it immed i at el y. If the remote control have lost the connection to the recei ver, it
can be reconnected as follows. At first looe sen the 2 marked screws at the housing
and remove the cover. The receiver must be completely i ns t all e d in the vehicle to
get power.
2 Now press 1 ti m e the highlighted button on the board. Afterwards the LED beginns
to light. Then hold the marked button at t h e remote control until the relais clicks
1 time. Following the button is programmed and the LED turns off again.
3 Now press 2 times in short distan ce the marked button at the board and as soon as
the LED b egi n ns to light press the highlighted b ut t on on the remote control. Upon
successful programming, the marked LED turns off and the relay clicks 1 time.
Kufatec GmbH & Co. KG - Dahlienstr. 15 - 23795 Bad Segeberg - e-mail: [e-mail] 10