Instruction Manual
12 Note
Troubleshooting
• If the remote control does not work, please proceed as follows:
• If it is not possible to change the mode (e. g. mode 5 to mode 6) via the remote control, Drives-
elect might be active. The module changes shortly to mode 6 and right back to mode 5 in
that case. This can be fixed by deactivating Driveselect either through the Soundbooster-App
or through the PC Sof tware.
• If Driveselect is not active, check if the remote control controls the modu l e. While using the
remote control, you should be able to hear a click noise in the module.
• If you can’t hear the click noise in the module, the remote control has to be trained to the
module again. How to train the remote control can be fou n d in the manual in section Remote
Control Programming.
Kufatec GmbH & Co. KG - Dahlienstr. 15 - 23795 Bad Segeberg - e-mail: info@kufatec.de 11