Phau Ntawv Qhia

The external Sound Generator will be mounted behind the engine block (Figure 1). To do this, loosen the

marked screw (1x 16er Nut) and then mount the sound generator with this screw on the vehicle. In

addition the sound generator is mounted with an M10 (not included in the scope of delivery) on the

existing stud bolt (Figure 2).

If there are strong vibrations inside the car after the installation, you can use rubber buffers (not included

in the scope of delivery) at the mounting points.

Figure 1 Figure 2

Now attach the supplied steel cable at the sound generator as well as on the vehicle.

Figure 3

As an additional safeguard the included steel cable and associated clip must be attached to the

sound generator and at a suitable location on the vehicle. This is an additional security, in case

of losing the fixing screw by vibrations.

For attaching the sound generator use suitable screws which can withstand a high load. To

avoid losing the screws by vibrations, secure the screws with suitable workshop material.

Check periodically the stability of the noise generator and tighten the screws if necessary. In the

case of a non-compliance, we assume no liability for any damages.