Corp. Mixer User Manual

6
3000STOPR005810R082503
SAFETY DECALS
SAFETY DECALS ARE PLACED ON THIS UNIT FOR THE PROTECTION OF THE OPERATOR OR ANY PER-
SON NEAR THE UNIT.
Be Sure everyone who operates the mixer understands all the information, warning, caution and danger
decals.
Keep The Decals Clean so they are readable. This applies to all caution, warning, and danger decals.
It is the OWNER’S RESPONSIBILITY to provide information for safe operation of this machine.
Replace any damaged or worn decal. Once any part of a decal becomes non-readable, it should be replaced.
The part numbers for the decals are located in the lower RH corner of the decal, and listed in this manual on the
following pages. Replacement decals may be ordered through your dealer or the address below.
When replacing decals, be sure the surface area is clean and dry, peel the backing off the decal, and apply to
the Mixer. Be sure to wipe with a clean cloth to rub out all air bubbles to assure a good seal. For best adhesion
decals should be applied in temperatures of 50° (f) or warmer.
Complete sets of decals (including information decals) can be ordered by using the following part numbers:
UNIT PART NO.
3015 174-633
3020 174-630
3025 174-647
3030 174-650
3036 173-361
3042 173-362
3050 174-636
3060 174-639
3070 174-702
3095 175-013
SAFETY