Corp. Mixer User Manual
33
3100ST 006046 010507
Kuhn Knight, Inc.
1501 West 7th Ave., Brodhead, WI 53520
701 Cherry Ave., Greeley, CO 80632
Back to Table of Contents
PROBLEM: EXCESSIVE CHAIN NOISE
MISALIGNED SPROCKETS Check sprockets for worn edges of teeth. Use a straight edge to
verify the alignment of the sprockets.
WORN SPROCKET AND OR CHAIN Inspect sprockets and chains. Replace if excessively worn.
CAUSE SOLUTION
PROBLEM: SEAL LEAKING ON UPPER AUGER
CAUSE SOLUTION
PROBLEM: SEAL LEAKING ON INPUT SHAFT
OIL BATH IS OVERFILLED The oil level in the sealed drive compartment should be maintained
at the “oil level” plug on the drive compartment housing. This
allows the oil to be thrown onto all the other chains inside the
drive compartment.
SEAL IS DAMAGED Replace Seal
CAUSE SOLUTION
PROBLEM: FEED IS SEPARATING AS IT DISCHARGES FROM THE MIXER DOOR
CAUSE SOLUTION
TROUBLE SHOOTING
PROBLEM: MOTOR RUNS, BUT REEL AND AUGERS DO NOT TURN
CAUSE SOLUTION
SHEAR BOLT ON PTO DRIVELINE HAS SHEARED
BELTS ARE SLIPPING
BROKEN CHAIN
Replace with the same grade and size shear bolt. Do not use any
bolt other than the grade specified in the MIXER SETUP,
DRIVELINE SHEAR BOLTS section. If problem persists, call your
local dealer.
Adjust or replace belts ad outlined in the INSPECTION AND
ADJUSTS section. If problem persists, call your authorized Kuhn
Knight service dealer.
Make sure that mixer is not overloaded. Replace broken chain. A
spliced chain will not be as strong as a new chain and may break
in another place. Be sure to inspect bearings, bearing mounts,
and shafts for any damage caused by excessive pressure.
BOLTS MAY HAVE WORKED LOOSE ON SEAL RETAINER Tighten or replace bolts
SEAL IS DAMAGED Replace Seal
DOOR IS OPEN LESS THAN HALF WAY Hay mixed in the load will separate from the grain if the discharge
door is not open at least half way. Additional flow control plates
may be required.