Technical Specs
Table Of Contents
- Product Technical Specification Confirmation
- Product Name：QB-RS663 Card Reader Module
- Product Model：QB-RS663
- Product SN：QB-RS663-V0.1A
- 1.Product Introduction
- 2.Product Characteristics
- 3.Product Technical Specification
- 4.Product Picture
- 5.Product Specification Chart
- 6.Pin Definition Diagram
- 7.Communication protocol
- 8.Command Table
- 1. Get device information
- 2. Card search
- 3. Contactless CPU /M3 card reset
- 4. CPU card command interaction
- 5. M1 card verification password
- 6. M1 card reading
- 7. M1 card writing
- 8. Desfire card AID choice
- 9. Desfire card key authentication
- 10. Desfire card key modification
- 11. Desfire card read file
- 12. Desfire card write file
- 13. M1 card read file (merge instruction)
- 9.
- 10.Attention
- 11.Statement
Kunshan QuanBao Electronic Ltd.
— 2 —
1.Product Introduction
OM9663 is the main chip used on QB-RS663 RFID reader model.OM9663 is the multi-
protocol RF read card IC launched by NXP company.It is RF card reading IC with most
supported protocols so far. OM9663 is a highly integrated transceiver chip, which is used on
non contact communication for 13.56MHz. It directly drives the external antenna through
the built-in transmitter to communicate with ISO/IEC 14443A or MIFARE card without
additional active circuit.The digital module is responsible for all ISO/IEC 14443A framing and
error detection function(parity check and CRC )。
2.Product Characteristics
• Support SO/IEC 14443A/MIFARE as MIFARE Classic 1K，MIFARE Classic 4K，MIFARE
Ultralight，MIFARE Ultralight C，MIFARE PLUS and MIFARE DESFire;
• Support SO/IEC 14443IB
• Support the demodulation and decoding of felica coded signal. FeliCa receiver
devices provide demodulation and decoding circuits for FeliCa coded signals.It supports
FeliCa’s higher two-way transmission speed up to 424k bits/s.
• Support the passive initiator mode corresponding to ISO/IEC 18092
• Support ISO/IEC 15693
• Support the P2P passive initiator mode consistent with ISO/IEC 18092
• Support the close range communication protocol consistent with ISO/IEC 15693，
EPC UID and ISO/IEC 18000-3 mode 3/ EPC Class-1 HF.