User manual

7BFT01

Brake fluid tester

suitable for DOT4

Manual

The tester can be used as a digital brake fluid tester suitable for determining brake fluid

tester suitable for determining brake fluid quality. Developed for professional use in

automotive repair shops and in servicing. Quality is tested and indicated on five LEDs in

terms of “per cent of water in the brake fluid”.

Ready for Brake Fluid Test

Unscrew the brake fluid reservoir, and pull off the cap of the brake fluid tester. Dip the test

probes into the brake fluid up to the plastic rim of the device.

To check Fluid Quality

Press the button for power on, green Led will light up. Insert the tester into reservoir for one

second then the test result will be correctly indicated by LEDs. The tester will automatically

power off after 12 seconds of inactivity.

Product labelling indication

Green: Battery OK, i.e.: no water contained in the brake fluid.

Green/yellow: Less than 1 % of water content in brake fluid

Green/yellow/yellow: Approx. 2 % of water content in brake fluid

Green/yellow/yellow/red: Approx. 3 % of water content in brake fluid. The brake fluid

should be changed.

Green/yellow/yellow/red/red: At least 4 % of water content in brake fluid. The brake fluid

must be changed urgently! Extreme danger!

Note: the data above listed is for your reference only.

PAGE 1
7BFT01 Brake fluid tester suitable for DOT4 Manual The tester can be used as a digital brake fluid tester suitable for determining brake fluid tester suitable for determining brake fluid quality. Developed for professional use in automotive repair shops and in servicing. Quality is tested and indicated on five LEDs in terms of “per cent of water in the brake fluid”. Ready for Brake Fluid Test Unscrew the brake fluid reservoir, and pull off the cap of the brake fluid tester.
PAGE 2
  Battery: (incl.): one 1,5 V, type AAA Open battery cover like the right diagram Attention    Replace battery if the green LED not light up any longer after you press power on button. Wash the test probe with tap water after every use. In case of skin contact with brake fluid, thoroughly wash the affected skin or clothing with water.