Manual

19
Storing Data
After the measurement has been completed, it can either be exited with ESC, or the Save Data
menu can be opened by pressing the SEL key. The predened name of the measurement – De-
fault – followed by a number is displayed here. If the data is to be assignable later, you will need
to enter a unique name here. We recommend customer names or a number. The entry is made
by pressing the ▲ or ▼ keys, which allows scrolling through the alphabet and the numbers from
0-9. Press SEL to insert the desired character. The cursor position can be changed with the ◄
and ► keys.
This name will remain entered until it is overwritten again. This means that, when saving the next
measurement, if the customer is still then same, nothing will have to be changed. The number
of the measurement will increase automatically. You can then sort, print, and save the data in
the KE7200 Manager PC software (see page 22) according to the customer number or the
name. It should be noted that it is necessary to adjust the memory setting at the start of a new
measurement series at another system.
The second line displays the available memory space. A total of about 14,000 entries are pos-
sible.
Cable/Wire Search via the Port Finder Function (link blink func-
tion) or Search Tone (tone mode) (Ethernet cable only)
The KE7200 has two ways of identifying a known socket at the patch panel, switch, or hub:
Portnder Function (link blink function)
Plug the test cable of the KE7200 into the socket located in the room and select the Link Blink
test in the Cable/Wire Search menu.
It is veried whether the socket is active in the network. This is displayed in the status line of the
KE7200. When the connection is active, information about the Ethernet connection with the re-
spective detected speed is displayed. The associated port on the patch panel/router/hub/switch
will ash.
1
If the port is not active, No Connection will be displayed. Then you will need to proceed with
tone mode.
Search Tone (tone mode)
Then you can switch to the tone mode in which one of 4 tones (1000 Hz; 880/1000 Hz; 2600
Hz, and 2600/1900 Hz) is transmitted to all wire pairs by the KE7200. The P310 probe can then
be used to search for the search tone at the patch panel/router/hub/switch and to unequivocally
identify the associated network port.
KE7200
Ethernet performance tester
ON-OFF
SEL
ESC
PROBE
inactive socket
> tone mode
Tonausgabe: 1000 Hz
Auswahl
SEL
ESC
Bestätigen Ende
Link
– Blink
880 Hz/ 1000 Hz
2600 Hz
1000 Hz
active socket >
portfinder funktion (link blink)
KE7200
Ethernet performance tester
ON-OFF
SEL
ESC
Tonausgabe: 1000Hz
Auswahl
SEL
ESC
Bestätigen Ende
Link – Blink
880Hz/1000Hz
2600Hz
1000Hz
1 It may be necessary for the ltering of the NLP signal to be deactivated in the settings of the
hub/router/switch.