Manual
22
Data Transmission and Management of Measurements
and Log Generation with KE7200 Manager PC Software
The KE7200 Manager PC software is a exible tool for conguring the KE7200 and for download-
ing test/measurement data from the measuring instrument.
It provides the following functions:
• Conguration of the manager (columns, language)
• Display of the KE7200 hardware version
• Display of the current KE7200 software/rmware version
• KE7200 rmware update
• Display of the KE7200 operating instructions
• Transfer of tests/measurements from the KE7200 to a PC
• Adding/deleting of loaded test/measurement data
• Storing of tests/measurements
• Retrieval of stored tests/measurements
• Log generation (printing)
Installing KE7200 Manager
KE7200 Manager is only available as a Windows versions for systems as of Windows 10 and
newer.
You can download the KE7200 Manager for free from our website:
https://www.kurthelectronic.de/ke7200-downloads/?lang=en
Run the .exe le on the PC to install the program. This creates a screen shortcut on the desktop
for launching KE7200 Manager.
Starting KE7200 Manager and Transferring Measurements
Connect the KE7200 to the PC with an Ethernet cable.
Then launch KE7200 Manager on the PC. Once the program has been called up, KE7200 Man-
ager will display its version number. Enter the IP address of the KE7200 under Cong.Table /
IP (can be viewed or congured in the instrument; see”Settings > IP Address” on page 17).
Close the program.
Now open Windows Control Panel and call up Network and Sharing Center > Change Adapt-
er Settings. Select the appropriate Ethernet adapter from all those displayed and open its Prop-
erties.Select Internet Protocol, Version 4 (TCP/IPv4) from the list and open Properties. Select
Use Following IP Address and enter the IP address of the KE7200 for IP Address and click in
the Subnet Mask eld so that it is lled in automatically. Conrm with OK.
Then restart KE7200 Manager on the PC. Select Transfer Measurements in the KE7200. The
stored data are transferred immediately after synchronization and appear in KE7200 Manager.
The KE7200 can now be disconnected again.
If no stored measurement data are available, this will be displayed. The data on the KE7200 can
now be deleted or aborted with ESC.
Program Operation
You can switch between the cable tests and network tests via the tab (see marking in the screenshot).