Manual
24
> Load Data (PC)
Tests/measurements that have already been saved can be opened for display here (.eth le).
> Save All Data
Here the data transferred by the KE7200 are selected for saving on the PC (.eth le).
> Save Displayed Data
Once the data has been selected, it is saved as a separate list (.eth le).
> Delete Marked Line
This deletes a complete line of test/measurement results.
> Print Data
A print version (log) of the measurements is created. You can store your compa-
ny logo here to display it in the log. A graphics le (.bmp, .dip, .jpg, .gif, .wmf, .emf,
.ico, .cer) is displayed at the top right edge of the sheet. We recommend a max-
imum size of 400 px in width × 250 px (width × height) at a resolution of 300 dpi.
You can also make further settings to customize the appearance of the test report.
> Conguration Table / IP
The IP address of the KE7200 for data transmission is entered in the upper area here. See “Start-
ing KE7200 Manager and Transferring Measurements” on page 22
The presentation of the displayed data (table columns) can be changed in the lower area.
> KE7200 Update
This menu item is used for installing software/rmware updates; see page 24.
> Instructions
Calls up the instructions for the KE7200.
> Show Following Measurements
After all data records have been downloaded from the KE7200, it is possible that they involve
data or measurements from dierent customers. However, this assignment must already be done
in the KE7200 when saving on location. You can sort the data by customer or make a selection.
A list with all saved data sets will open. You can then select the customer you want to summarize,
comment on, and print out as a report.
This selection can then be saved with Save Shown Data by entering their data (customer name,
number, etc.).
> Customer Address, Comment, Technicians
In the lower area, you have the option of entering the customer address, the technician, and any
comments. The address entered in the rst data set is shown as the rst item on the report. The
technician, location name, and comments can be entered separately for the individual data sets.