User Manual

PAGE 2
302716
DPF-MRK-003 REV A 4/18/16
ROADTHUNDER BLUETOOTH AUDIO CONTROLLER 2716
866 277 9598 | [e-mail]
454 COUNTY ROAD VV SOMERSET, WI 54025
KURYAKYN.COM
INSTALLATION INSTRUCTIONS
-CONTINUED-
INSTALLATION
The RoadThunder Bluetooth Audio Controller can be used with any external 12-volt amplifier and can be mounted in a variety of ways using the included
hardware. The unit has three wires in its wiring pigtail.
STEP 1
The red wire, hot, should be directly connected to the vehicles positive battery terminal.
The black wire, ground, should be connected directly to the vehicle’s chassis where paint has been
removed or the negative terminal on the battery.
The blue wire, remote, should be connected to the remote wire input on the external amplifier being
used.
When the RoadThunder Bluetooth Remote Control is powered On, a remote signal will be sent from
the controller to the connected amplifier, turning it On.
MOUNTED
CLAMP
The unit can be clamp mounted using the included hardware.
Mounting Bracket 7/8”-1” Bars
Mounting Bracket 1-1/8”—1-1/4” Bars
VHB Double Sided Foam Tape (Optional)
M14-2.0 Nut (to be hand tightened only)
REMOTE OPERATION
STEP 1
Play/Pause - The Play/Pause button gives you the ability to play or to pause the current track with
a single press. Holding the Play/Power button for 2 seconds will turn the unit On if currently Off or
Off if currently powered On. The unit will beep to indicate when power is turned Off.
Note:
a. The unit will stay on indefinitely as long as a Bluetooth device is actively paired to the any
self-amplified speakers.
b. The unit will turn Off after 5 minutes when there is no active Bluetooth device connection.
c. The Play/Pause button will illuminate when the unit is powered On.
d. The Play/Pause button will blink when the music track is paused.
STEP 2
Track Forward and Track Back - The unit will switch audio tracks being played by pressing the track
forward and track back buttons. Pressing and holding these buttons for 2 seconds will fast forward
or rewind the audio track that is being played.
STEP 3
Volume Up and Volume Down - These buttons will turn up or turn down the output of the Bluetooth
unit so any external connected amplifier output will go up or down accordingly. When the unit has
reached the minimum or maximum output level, the unit will beep to indicate that no further adjust-
ment is possible.
BACK VIEW FRONT VIEW