Specifications

Setup Mode
The Setup Editor
7-11
Knobs, CC Pedal, Modwheel, Pitchbend up/dn (Pitch Wheel,) Pressure
TheparametersfortheKnobs,CCPedal,Modwheel,andPressurearethesame(seeanexample
oftheKnob1page,below.)TheparametersforthePitchWheelarethesame,butthereisa
separatepageofparametersformovingPitchWheelup(Pitchbendup)andmovingitdown
(Pitchbend
dn.)
ThePC3LEfeaturesmonopressure,commonlycalledaftertouchonotherkeyboards.
Awordaboutpressure:KeyRangeinazonedoesnotdefinewhichnoteswillgeneratepressure
inthatzone.Ifpressureisenabledinazone,playingwithaftertouchanywhereonthekeyboard
willproducedata.Forexample,
ifZone1’sKeyRangeisC3–C5andyouplayC2andpush
downonthenote,pressuremessageswillbesentfromZone1.Aswithanyotherphysical
controller,however,youcandisablepressureinanyzone,orscaleitoroffsetitdifferentlyinthe
variouszones.It
mighthelptothinkofpressureasanextrawheel—wheelsoperateinazone
regardlessofKeyRange,andsodoespressure.
Note:AsidefromthePressuresettingsontheControllerspage,MIDIpressurevaluescanbeaffectedby
settingsyoumakeonotherpages:SeePressureMap(PressMap)(Master)
on page 9‐5foranoverall
settingthataffectsallMIDIpressurevaluesinputtothePC3LE,andallMIDIpressureval uessenttothe
internalsoundengineandUSBorMIDIoutports(exceptforpressurevaluesoutputwheninSong
Mode.)SeePressureMap(Transmit) on page 9‐15forsettingsthat
affectonlythoseMIDIpressure
valuessenttotheUSBorMIDIoutports(exceptforpressurevaluesoutputwheninSongMode.)See
PressureMap(Receive) on page 9‐19forsettingsthataffectonlythoseMIDIpressurevaluesreceivedby
theUSBorMIDIinports.Oneachofthepages
mentionedabove,lookattheMIDIsignalflowchartto
seewhichpressuremapscanaffectyourvelocitiesdependingonwhichMIDISources,MIDIDestinations
andoperatingmodethatyouareusing.
Parameter Range of Values Default
Scale ±300% 100%
Curve Linear, Compress, Expand Linear
Offset -128 to +127 0
DestType (Destination Type) Ctrl, Param Dependent on controller
Destination (Dest) Control Destination List Dependent on controller
Entry Value None, 0 to 127 None
Exit Value None, 0 to 127 None